Plastic Melt Flow Rate Tester

Used to determine all kinds of plastics, resins in viscous flow state through a certain temperature and load, every 10min through the standard mold melt flow rate MFR value, it is suitable for high melting temperature polycarbonate, polysulfone, fluorine plastics, nylon and other engineering plastics, It is also suitable for polyethylene (PE), polystyrene (PS), polypropylene (PP), ABS resin, polyformaldehyde (POM), polycarbonate (PC) resin and other plastics melting temperature low test, widely used in plastic production, plastic products, petrochemical industry and related colleges and universities, scientific research units and commodity inspection departments.

Description

Features of Plastic Melt Flow Rate Tester

1, Chinese and English color LCD display

2, hand automatic cutting material

3, double temperature control system, temperature control precision is more accurate, higher heating efficiency

4, double inlet sensor, upper and lower temperature gradient is more accurate, can be used independently, improve the service life

5, the cylinder is imported Hastelloy nitriding treatment, the die is made of carbon tungsten steel, the material is real

6, insulation bucket for all sus304 stainless steel material, long-term high temperature does not rust

7, automatic calculation results, and print out

Parameters of Plastic Melt Flow Rate Tester

Temperature range:	0 ° ℃ - 450 ℃	Temperature fluctuation:	Plus or minus 0.2 ℃
Temperature uniformity:	±1℃	Temperature display resolution:	0.1 ℃
Time display resolution:	0.1 S	Displacement accuracy:	The 0.001 mm
Volume timing:	0.001 S	Range of test results:	50-5000cm /10min
Cylinder diameter:	Ф2.095±0.005mm	Length of discharge port:	8.000±0.025mm
Diameter of charging cylinder:	Φ9.550±0.025mm	Precision of weight:	Plus or minus 0.5%
Output mode:	Micro automatic printout	Cutting method:	Hand automatic cutting material in one
Test load:	Full set of grade eight weights	Power supply voltage:	AC220V±10%/50HZ